Best Way to Clean Outside of House Windows

Window Washing Tips and Techniques

The fastest way to wash your windows with crystal clear, streak-gratis results.

1 / 11

Family Handyman

Basic Window Washing Equipment

2 / 11

Family Handyman

DIY Window Cleaning Solution

The best homemade window cleaning solution is to only mix two gallons of h2o and virtually a teaspoon of dishwashing liquid together in your bucket. Some people also opt to use vinegar and water to make clean windows.

In warm weather, y'all'll get a little more working fourth dimension by using cool water. If you've procrastinated so long that yous're washing windows in beneath-freezing temps, add windshield washing solution until the water doesn't freeze on the glass.

3 / xi

Family Handyman

Scrub the Glass

The first step in the exterior window cleaning process is to scrub the glass, working at all angles to clean the edges. Make sure to cover every square inch of the glass. This technique allows y'all to get great results immediately. We're moving the squeegee horizontally across the glass, but vertical strokes volition piece of work also. If you work vertically, bending the duster to direct backlog water toward the uncleaned area.

iv / xi

Family Handyman

Make clean a Starting Strip

Tip the duster and so that only the corner contacts the glass. And so, starting at the top corner of the glass, clean a narrow strip of glass from top to bottom on 1 side. This clean strip makes it easier to start the horizontal stokes.

5 / 11

Family Handyman

Duster Across the Height

Press the squeegee blade against the drinking glass in the upper corner and pull it steadily across the window. Concentrate on keeping the top of the squeegee in contact with the pinnacle edge of the window.

vi / 11

Family unit Handyman

Wipe the Squeegee Clean

Wipe the blade on the clean towel in your front end pocket or wipe it across the scrubber to remove dirt and excess water.

7 / xi

Family Handyman

Work Down the Window

Begin once more, with the acme of the squeegee overlapping the previous stroke near 2-in. Pull the squeegee across the window at an angle to direct excess water downward. Wipe and echo.

8 / eleven

Family unit Handyman

Wipe Off Excess Water

The next step in exterior window cleaning is to utilize the rag in your pocket to wipe upward excess water along the bottom edge of the window. Then poke your finger into a dry spot on a divide lint-free rag and run information technology around the perimeter of the window to remove whatever remaining suds. Wipe off whatever streaks using a clean expanse of the lint-costless rag. Change rags when you can't find any fresh, clean areas.

nine / xi

Family unit Handyman

You lot Can Use a Duster Inside the Firm, Too!

Pro cleaners utilise squeegees inside all the fourth dimension, even in houses with stained and varnished woodwork. When cleaning windows with a squeegee indoors, the key is to clasp most of the soapy water out of the scrubber to eliminate excessive dripping and running. Then rest the scrubber on the edge of the bucket rather than dropping it in the water after each window. Depending on how muddied your windows are, you may be able to wash five or 10 windows before rinsing the scrubber.

Proceed a rag in your pocket to wipe the squeegee and chop-chop clean upwards soapy water that runs onto the woodwork. Use a dissever clean rag to wipe the perimeter of the glass. Microfiber rags besides work great for window cleaning.

ten / eleven

Family Handyman

Changing a Squeegee Bract

• Remove the worn out blade.
• Grab the end of the bract and stretch information technology out to expose the metallic clip.
• Slide the prune off, then slide the blade out the contrary stop.
  • Pro tip: Blades without clips are ordinarily held together by a couple of screws and the clamp on the handle.
• Install the new blade.
• Slide it into the metallic channel.
• Stretch it and reinstall the metal clip.
  • Pro tip: If necessary, cut the end of the bract to exit one/viii to three/16 in. protruding from the channel.

Family Handyman

11 / 11

Family unit Handyman

Tips for Hard-to-Clean Windows

Remove paint specks and labels with a razor bract mounted in a holder. Always use a new blade to avoid scratching the glass. Wet the window offset and push the blade beyond once. Rinse the bract and repeat on the next department to avoid trapping debris under the blade that could scratch the glass. Don't use a razor blade on tempered glass.

• Remove tree pitch or problems droppings with a fine (white) nylon scrub pad. Wet the drinking glass first and rub in an camouflaged area to make sure yous're not scratching the drinking glass.
• Clean tough glass stains and built-upwards mineral deposits from shower doors and other glass surfaces using mild household abrasives and an ordinary power drill.
• Apply this glass cleaning solution for tough spots: Add i/2 cup of ammonia per gallon of h2o to assist remove greasy dirt for a DIY window cleaner
• Loosen sticky rest left from labels or tape by soaking it with a specialty product like Goof Off. Y'all'll notice Goof Off in the pigment department at hardware stores and home centers. And then scrape off the residue with a razor blade.

Originally Published: June 24, 2019

hydeaftecte.blogspot.com

Source: https://www.familyhandyman.com/list/how-to-wash-windows/